Further Possible Mower Handle Adjustments and Reducing Length

  • 3
  • Idea
  • Updated 3 years ago
  • Implemented
  • (Edited)
After thoroughly going over and comparing against gas mowers I think there are a couple aspects in addition to some already mentioned (brushless, self-propelled) that could improve this mower significantly.

It looks like the design language is more akin to a racecar where it is long and swept back. Unfortunately with the handle this makes it trickier to maneuver in smaller places and leads to much more trimmer work than regular gas mower.  Because the handle has to be extended to pretty much full length for it to start, it prevents it from being nimble in tight corners.  In addition, it doesn't go high enough, another hole in the adjuster on either side would do wonders.

The front wheels and deck extend further forward from the shaft compared to more traditional mowers which when cutting towards an object and stopping (say a wall) the blade doesn't get close enough.  There looks to be enough room to bring the wheels closer back towards the cutting area and shortening the whole deck.  To counteract this however, there needs to be more forward weight balance which is lacks down-force on the front wheels compared to other mowers. I think it would be easiest to just move the battery pack forward a couple inches.

I think both of these points would make it a much more appealing product.
Photo of Prae

Prae

  • 102 Points 100 badge 2x thumb

Posted 5 years ago

  • 3
Photo of Jennifer VandeWater

Jennifer VandeWater, Community Manager

  • 80,908 Points 50k badge 2x thumb
Official Response
Thanks for all of the feedback.  We will be sure to keep that in mind for future designs.  We appreciate it!
Photo of eric

eric

  • 80 Points 75 badge 2x thumb
I've read comments at the HD site that seems to suggest that some customers are able to operate the mower with the handle in the lower position. I thought an EGO rep may have also suggested the same there as well. My mower will power off if I lower the handle. For me, a lower handle position is preferred.
Photo of Jennifer VandeWater

Jennifer VandeWater, Community Manager

  • 80,908 Points 50k badge 2x thumb
Eric, we think we're getting lost in the terminology.  There's a difference between lowered handle and extended handle.  The mower won't operate without the handles fully extended and the handle locking clamps locked down.  However, there are two heights you can adjust the handles to.  There's a higher and lower setting.  The quick-adjust lever is on the left side of the mower, above the rear wheel, behind the deck adjustment handle. Does this help?  We included a picture below that shows the quick-adjust lever we are referring to.

Photo of eric

eric

  • 80 Points 75 badge 2x thumb
You are correct, it is a terminology mixup. I'm referring to extending(or not) the handle. I (would)prefer to not extend it.
Photo of Stan T

Stan T

  • 80 Points 75 badge 2x thumb
Jennifer,

this feedback helped me. I had some trouble understanding handle adjustments. Just got my mower from HD last night..

Thanks!

Stan
Photo of SCDC

SCDC, Champion

  • 54,328 Points 50k badge 2x thumb
Maybe they are mistaken and actually talking about the height of the handle verses the pull out length.  I cannot run mine unless it is fully extended either.  Would be interesting to find out.
Photo of Jennifer VandeWater

Jennifer VandeWater, Community Manager

  • 80,908 Points 50k badge 2x thumb
All EGO Power+ mowers in the market cannot be operated without the handles fully extended.  That was part of the design.  We have heard some feedback asking for what you've mentioned (shorter handles, without being fully extended) and we're looking into that for a possible change in the future.
Photo of Susan J.

Susan J.

  • 60 Points

um.., then why have a shorter extension available???


Photo of Blue Angel

Blue Angel, Champion

  • 179,118 Points 100k badge 2x thumb
Susan, having the handles extended all the way is a safety feature. I assume it's there to ensure no one could operate the mower while having their feet too close to the blade.

The request is for a handle that has more than one position where the handle can lock into place and the mower can operate. This would effectively shorten the handle as well as lowering it, making it easier to manoever in tight spaces as well as offering a lower position for shorter people.
Photo of David

David

  • 192 Points 100 badge 2x thumb
I bought an EGO mower last week, and it's great - save for the handle being too long - making it less comfortable / ergonomic (for me) to use and more difficult to maneuver around tight spaces. I"m sure having that handle at that long extended length is probably a safety feature; but it's the only thing about the mower that I don't like. I'm sure several owners have found a way to operate the mower with the handle in the lowest position. Has anyone here modified their mower for it to operate without extending the handle?
(Edited)
Photo of Blue Angel

Blue Angel, Champion

  • 179,118 Points 100k badge 2x thumb
David, while I'm sure it's possible, I doubt the Ego staff would condone a modification to one of the safety systems on the mower.

As you can see from the above conversation, the request is a popular one and I'm sure they will take it into consideration if/when a new mower design is released.
Photo of Gary

Gary

  • 80 Points 75 badge 2x thumb
Yes, I agree.  Modification of a safety feature is a bad idea.
Photo of David

David

  • 192 Points 100 badge 2x thumb
Thanks for the quick reply, though waiting for a new model to come out really isn't a solution for my brand new, 1-week old mower. IMHO, the length of the handle is ridiculous and also causes a weak joint at the clamp (when the handle is fully extended). That's probably why they needed to design a new clamp and send out the replacement to customers. As far as safety is concerned, I suppose the remote possibility exists that a customer could fold up the mower to store it with the battery in place where the key and handle switch could inadvertently get tripped and start the motor. I"m sure that's why they make customers extend the handle before using it. For me (and I'm sure 99% of other owners), I just remove the battery and place it in the charger before storing the mower.

Google is our friend. I'll keep searching for a way to do the modification on my own. For me, (being 5'9") the non-extended handle length is ergonomically perfect, and would allow me to zip around tight spaces with ease.
Photo of Blue Angel

Blue Angel, Champion

  • 179,118 Points 100k badge 2x thumb
"...I dropped my Samsung Note 2 on a client's floor and shattered it..."

I have to ask, given the size of the Note, was it the phone or the floor that shattered?!?

Can you tell I have an iPhone? :-)

BTW, must have iP6s, or whatever they call it... must have it... must have it... as I foam at the mouth mindlessly surfing for Apple rumors. Hey, that's what I've been trained to do, just following orders, probably given to me subliminally through contact with my iPhone.

"Maybe it'll come in yellow!"

Mind
Blown
Photo of David

David

  • 192 Points 100 badge 2x thumb
Apple fans used to laugh at the size of my phone until HQ "Invented" the revolutionary IP6+. It's now become cool to walk around with a big phone. In 1990, I used to think that my Motorola 8000M was a cool phone. Was it a cell phone, or a device you'd use to call in an airstrike?

No offense intended. Apple makes great devices. My point is that last year's device isn't necessarily as obsolete as Apple (or Samsung) would like everyone to believe.
Photo of Blue Angel

Blue Angel, Champion

  • 179,118 Points 100k badge 2x thumb
Haha, no offense taken! My buddy has a Note (2 I think) and we're always bugging each other.

My dad used to rock a Motorola 8000, he was in real-estate in the late 80's - early 90's:



More disposable conspiracy theory; he claimed that phone worked better than the newer digital phones and kept it alive until the service providers no longer supported them! Might have been something to do with the mega power output frying brain cells too, but hey, it was a cool phone!!!
(Edited)
Photo of Jennifer VandeWater

Jennifer VandeWater, Community Manager

  • 80,908 Points 50k badge 2x thumb
We love reading these discussions.  Sometimes everyone goes off on a tangent but it's easily brought back with the retro phone picture!  :)  We still don't have a handle redesign but we are watching this thread and continuing to relay your feedback to our design team.
Photo of SCDC

SCDC, Champion

  • 54,328 Points 50k badge 2x thumb
Just give it an iHandle and everyone will be happy regardless of length.  :)   Thanks Jennifer.
Photo of Gastro Enteritis

Gastro Enteritis

  • 80 Points 75 badge 2x thumb
You know, hypothetically (or as in my case, actually) - if your clips are working correctly there is no real need for the little safety pins that go through the fully extended and fully retracted position holes (they are just there as an extra safety feature in case the brakes slip) so if the kill switch actuator cam is removed from the plastic T joint on the right hand side of the mower (which is very easily and reversibly done) then you can have "infinite" adjustability with a working mower.  Granted this will allow you to start the mower with the handle at its very shortest so the operator needs to be conscious of the dangers, but it does allow for a more convenient working length and the ability to access awkward areas in the garden.

Also of course, the key and dead man lever are still required to start the motor, so still relatively safe
 
If you are one of the lucky ones who have needed replacement clips then you can modify your old ones only, thus giving you the ability to revert the mower to stock standard should the need arise.

Just saying...