Edger and power head shaft don't line up

  • 1
  • Question
  • Updated 3 months ago
  • In Progress
Just got the powerhead + edger.  Once I got everything hooked up, I noticed the edger is tilted 15-30 degrees if i have the powerhead level.  To get edger 90 degrees to the ground, i would have to tilt powerhead with thumb going downward.  I find it a little awkward.  Anybody else have this issue?  Can the edger be adjusted?  Or was this by design?
Photo of dhau001

dhau001

  • 1,786 Points 1k badge 2x thumb

Posted 3 months ago

  • 1
Photo of Jacob

Jacob, Champion

  • 59,398 Points 50k badge 2x thumb
Official Response
Did you tighten the locking knob? If so please send a picture