Can anyone explain how to remove your light assembly and install the new one on my ego lawnmower

  • 1
  • Question
  • Updated 3 years ago
  • Answered
Installation help light assembly
Photo of David Millsaps

David Millsaps

  • 70 Points

Posted 4 years ago

  • 1
Photo of Blue Angel

Blue Angel, Champion

  • 180,038 Points 100k badge 2x thumb
David, are you replacing a defective light module? If so a warranty repair might be your best bet.

If the mower is not under warranty, you may just have to start taking the mower apart until you get to the lights... as far as I know there are no tear down procedures available.
Photo of (a)Typical Engineer

(a)Typical Engineer

  • 26,632 Points 20k badge 2x thumb
For the 20" mower, you remove 3 or 4 screws from the inside of the battery box, and then lift it up and out so that you can get to the wires, then disconnect them.  The LED headlights are another connector that goes back to the control module on the controller on top of the motor.  The LED is a small 1/2" wide ribbon cable, grey IIRC.